 |
Glassblowers Burners
|
 |
|
|
Glassblowers Burners
|
|
| There is a wide variety of glassworking torches and burners available
to the glassblower. The following is intended to be a representation of
the burners and torches found in a typical scientific research glassblowing
shop.
The gases commonly used for working borosilicate glasses are propane or natural gas mixed with oxygen. It is important when selecting your burner, torch and tips that they be designed for use with these gases. Units designed for gas/air mixtures should not be used with gas and oxygen. |
 |
Typical glassblowers burner. Burners are usually bench or lathe mounted. The bench burner shown here has two gas and two oxygen valve controls, offering a wide variety of flame configurations. The aluminum collar shown mounted on the burner barrel aids in heat dissipation. |
 |
Another example of a glassblowers bench burner. The two inner valves (green/oxygen and red/gas) create a relatively small tight flame. Opening the two outer valves offer the glassblower a much larger flame as shown here. In use, burners are usually stationary or mounted as part of a fixture. The glass is brought into the flame where it is heated and manipulated by the glassblower. |
 |
Lathe burners are mounted on a movable carriage. The four (4) jet burner pictured can be moved up or down to match the diameter of the glass being worked or rolled back and forth along the length of the glass tubing using the carriage. Each burner jet angle may be adjusted as well. |
 |
Glassblowers torches are usually smaller and much lighter than burners
or burner
assemblies. The torch shown here is a pre-mix (gas/oxygen are mixed in a chamber within the torch body) style quite popular with many glassblowers. Pre-mix torches often have removable tips in a wide range of sizes, providing a number of flame options to the glassblower. |
 |
Torches are brought to the glass, which is held stationary by clamps or other fixtures. The size, weight and balance of a torch are important features to the glassblower. |
photo copywrite - Dean Master |
Torches and Burners come in a variety of shapes, sizes and capabilities
to fill the many applications required by the glassblower. Traditionally
made of metals such as stainless steel, brass, etc., there have been special
needs that require custom fabrication using non-traditional materials.
For example: Potential metal contamination from a hot torch may cause problems
in the glass product. A solution - the development of the glass (quartz)
torch. Additional photo's and information may be found at:
http://www.blueflametech.com |
|
|
|
 |
© 2002