 |
Calipers |
 |
|
Calipers |
|
| Calipers are used by glassblowers to measure outside diameters (OD), inside diameters (ID), wall thickness and other dimensions specified by the drawings used in fabricating glass apparatus. |
 |
Vernier calipers (top) and electronic calipers may be two of the most
widely used styles of calipers in the glass-shop. Electronic calipers are
relatively expensive compared to the standard vernier style and not as
tolerant to heat and chemical exposure. They are quite accurate, quick,
and easier to read, however.
|
 |
Vernier caliper measuring the outside diameter (OD) of a heavy wall glass tube. The two "prongs" on the top of the calipers are used to measure internal diameters. |
 |
Close-up view of the calibration markings on a vernier caliper. Upper markings on this caliper are metric, the lower markings are English. The measurement shown is 4.66 cm. |
 |
Electronic calipers have a window for a digital display. Most electronic calipers have a number of optional controls such as metric to english conversion, memory and adjustable start points. |
 |
Spring-loaded OD Calipers are an inexpensive alternative to vernier calipers. They do have limitations - primarily in accuracy and versatility. Advantages other than cost may be in the increased measuring capacity or range, and heat tolerance when making rough measurements during the glass fabrication process. The horizontal threaded rod contains a thumbwheel for adjusting the width of the two measuring arms. |
 |
Spring-loaded calipers do not have calibrations. You obtain measurement by placing the measuring arms against a rule (stainless steel ruler with english and metric scales shown). As you can see the accuracy of this tool and method does not compare with the accuracy of the vernier or electronic caliper. |
 |
Spring-loaded ID Calipers have the same features and limitations of the OD Calipers. The difference is in the shape/orientation of the measuring arms allowing access to the inside of the glass tubing. |
 |
|
|
|
 |